![]() ![]() Then, Steve planed the opposite face as well. You can see some of the rough sawn marks as well as some knots.Īfter jointing one side and one of the faces flat and square to each other, we moved to the table saw and cut the opposite side of the boards parallel. ![]() Luckily these boards will ultimately be taken down to 1″ thick so we can plane past most of the problem areas. To clean off the old stain and locate the best sections of each board, we started by planing and jointing the faces.Ī few years of air drying and use has caused a bit of twist in some of the boards. They were originally cut for a bed and allowed to air dry. He had some ash boards that were reclaimed from a previous project and he wanted to make a custom guitar with them. I had the opportunity recently to work on another guitar with my friend Steve. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |